GiBiDi SC130 Instructions Pour L'installation page 10

10
UK
CONNECTIONS
Terminal Abbrev.
1 PH
2 NEUT
3 MOT COM
4 CLOS
5 OPEN
6 LAMP
7-8 FCA-FCC
9 COSTA
10
PHOTO
11 COM
12 UP
13 DOWN
14 12VDC
15 COM
ANT
DIP SWITCH SW1
DIP ON
DIP 1 FRAME Input disabled
DIP 2 OPENING LIMIT SWITCH Input disabled
DIP 3 CLOSING LIMIT SWITCH Input disabled
DIP 4 PHOTOCELL Input disabled
DECELERATION enabled.
After the intervention of the limit switch, the motion
DIP 5
goes on for 1s in deceleration.
Description
Line 230Vac PHASE Input
Line 230Vac NEUTRAL Input
Motor COMMON
Motor CLOSE
Motor OPEN
Courtesy light / Flashing light
OPEN-CLOSE (N.C.) Limit Switch
Frame NC/8K2 Input (see DIP9)
Photocell Input (N.C.)
Accessories Inputs-Outputs Common
START Input (N.O.)
PEDESTRIAN Input (N.O.)
12 Vdc for ACCESSORIES
power supply
Accessories Inputs-Outputs Common
ANTENNA CORE
(wire solded on circuit)
Operation
Protected by F1 5A.
Connect the flashing light or the courtesy light
between NEUT and LAMP (terminals 2-6) and
consequently set the DIP10.
If you use the courtesy light, connect the
flashing light (with its flashing circuit) between
MOT COM and CLOS (terminals 3-4).
Stop the motion in OPEN AND CLOSE or define
the beginning of the deceleration (see DIP 5).
If not used, set DIP 2 and 3 in ON.
If not used, set DIP1 in ON and DIP 9 in OFF.
In OPENING stops and releases the obstacle
for 2 s.
In CLOSING opens again.
In PAUSE operates as STOP and cancels the
automatic reclosing.
If not used, put DIP4 in ON.
In OPEN irrelevant.
In CLOSE opens again.
The gate opens for 7 s. A START makes open all
and interdicts the pedestrian.
Protected by F2 500mA resettable.
OFF
FRAME Input enabled
OPENING LIMIT SWITCH Input enabled
CLOSING LIMIT SWITCH Input enabled
PHOTOCELL Input enabled
DECELERATION disabled
SC130