Braun Multipress automatic MP 80 Mode D'emploi page 6

English
For UK only:
Warning
Your appliance is already fitted with a plug
incorporating a 13 A fuse. If it does not fit
your socket the plug should be cut off from
the mains lead and an appropriate plug fitted.
Throw away the cut off plug; do not insert it in
a 13 A socket elsewhere in the house as this
could cause a shock hazard.
IMPORTANT – Fitting a Different Plug:
The wires in the mains lead are coloured in
accordance with the following code:
Blue – Neutral
If the colours of the wires in the mains lead
do not correspond with the coloured markings
identifying the terminals in your plug, proceed
as follows:
The blue wire must be connected to the
terminal marked with the letter N or coloured
black.
The brown wire must be connected to the ter-
minal marked with the letter L or coloured red.
Never connect the blue or
brown wire to the earth pin
(E), when using a three pin
plug. The appliance must
be protected by a 13 amp
fuse if a 13 A (BS 1363) plug
is used.
The fuse cover must be refitted when changing
the fuse. If the fuse cover is lost do not use the
plug until a replacement cover is fitted. These
parts are available from authorised Braun
Service Dealers. Never use the plug without the
fuse cover fitted.
Caution
Read all instructions carefully before
using this product.
This product is suitable for normal household
use only and not for commercial use.
Keep out of children's reach.
Do not reach into the filling shaft while the
motor is running. Always use the pusher to
guide food through the shaft.
Remove plug from socket before assembling
or disassembling appliance.
Braun electric appliances meet applicable
safety standards. Repairs on electric
appliances must only be done by authorised
service personnel. Faulty, unqualified repair
work may cause accidents or injury to the
user.
6
Brown – Live
The mains cable of this appliance can only
be changed by an official Service dealer,
since it requires a special tool.
Specifications
Voltage/wattage: See typeplate on the
bottom of the appliance.
Safety system: The appliance can only be
switched on when the cover has been fully
locked into position and can only be opened
when the switch has been turned off.
Motor stop: The motor will stop completely
within 2 seconds of switching the appliance
off.
Safety fuse
If the appliance is overloaded the safety fuse
will cut out. To restart the appliance:
2
Turn the switch
Unlock and remove the cover
Clean the juice ring
Allow the appliance to cool down approx.
20 minutes.
Assemble the juicer again.
2
Turn the switch
If the appliance still does not run, allow it
to cool down again.
Description
1
Motor part
2
On/off switch
3
Unlocking buttons
4
Pulp container
5
Juice ring
6
Filter
7
Cover
8
Filling shaft
9
Filling tray
j
Pusher
k
Juice spout
l
Juice container with foam separator
m
Cord storage
Before using for the first time, wash the juicer
parts (see «Disassembling» and «Cleaning»).
Assembling
1. Put the juice ring
(fits loosely without engaging).
6
2. Lay the filter into the juice ring
7
3. Put the cover on and push down firmly
with both hands until you hear it snap into
place.
4. Hang the pulp container
(the top one first); then close it and be sure it
snaps into place.
off = «0» (important!).
7.
5 6
, filter and cover
on = «l».
5
on the motor part
5
.
4
onto the hinges
7
.
1