TFA 30.5032 Mode D'emploi page 8

TFA_No. 30.5032_Anleitung_09_21
Mould RADAR thermo-hygrometer
A 2: Indoor temperature (°C/°F) and humidity / Maximum and minimum values/
Dew point
A 3: Smiley for the comfort level
B: Front - Sensor buttons:
B 1: min/max button
B 2: Taupunkt (Dew point) button
C: Back - Slide switch
C 1: Alarm sound (Speaker symbol)
C 2: Animation (Arrow symbol)
D: Housing:
D 1: Suspension device
D 2: Battery compartment
D 3: Switch Taupunkt / dew point (inside the battery compartment)
D 4: Holder for the support
D 5: Warning LED when risk of mould
7. Getting started
• Remove the protective foil from the display.
• Open the battery compartment and remove the battery insulation strip.
• The device will alert you with a beep and all LCD segments will be displayed for
about two seconds.
• The indoor temperature, the humidity and the corresponding smiley symbol appear
on the display.
• The unit is ready for use.
• Attention: Do not attach the support until the settings for the animation and alarm
function are complete. The two slide switches are covered by the support.
8. Operation
8.1 Display of the 24 hours mould radar
• The device measures the relative humidity every 30 seconds and calculates from
these values every 10 minutes the average value.
• The innovative mould radar display shows graphically on a 24 hour timeline the
maximum averages that were reached.
14
12.10.2021 6:38 Uhr Seite 8
Mould RADAR thermo-hygrometer
→ The time "0h" represents the value of the current hour, "-1" the last hour "-3" of
the past 2-3 hours, "-6" of the past 4-6 hours, "-12" of the past 7 -12 hours and
"-24" of the past 13-24 hours.
→ The relative humidity values are shown in a grid of 10 from 15 to 85%. More
than 65% RH means risk of mould.
8.2 Activate and deactivate the animation
• Slide the right switch (arrow symbol) at the back forward using a pin and the auto-
matic animation of the 24-hour mould radar display is activated.
• On the display the black bars are flashing.
• When the animation is deactivated (switch below) the black bars appear permanently.
8.3 Activate and deactivate the alarm function
• Slide the left switch (speaker symbol) at the back forward using a pin and the alarm
sound is activated.
• If the humidity rises above 65%, an alarm sounds for a minute and a red warning
light flashes.
• Press any button to stop the alarm sound.
• The warning light continues flashing until the measured humidity is below 65%.
• Slide the left switch (speaker symbol) back using a pin and the alarm sound is
deactivated.
8.4 Comfort level
• The device shows two different indicators for the comfort level of the indoor cli-
mate:
• Smiling face: ideal values (40-60%)
• Sad face: too wet or too dry (< 40% or > 60%)
8.5 Display dew point
• With the switch inside the battery compartment can you change between the indica-
tion "Taupunkt"" (position left) or "dew point" (position right). Use a pin to slide the
switch.
• Press the Taupunkt button to show the current dew point.
• On the display "Taupunkt" or "dew point" will be flashing and the current tempera-
ture appears briefly.
• The display automatically returns to the current temperature and humidity.
15