Cognex In-Sight 8000 Série Mode D'emploi page 7

Do not expose the image sensor to laser light. Image sensors can be
l
damaged by direct, or reflected, laser light. If your application requires laser
light that might strike the image sensor, use a lens filter at the corresponding
laser wavelength. For suggestions, contact your local integrator or
application engineer.
This product does not contain user-serviceable parts. Do not make
l
electrical or mechanical modifications to product components.
Unauthorized modifications can void your warranty.
Changes or modifications not expressly approved by the party responsible
l
for regulatory compliance could void the user's authority to operate the
equipment.
Include service loops with cable connections.
l
Ensure that the cable bend radius begins at least six inches from the
l
connector. Cable shielding can be degraded or cables can be damaged or
wear out faster if a service loop or bend radius is tighter than 10X the cable
diameter.
This device should be used in accordance with the instructions in this
l
manual.
All specifications are for reference purposes only and can change without
l
notice.
6