Cognex In-Sight 8000 Série Mode D'emploi page 13

Connect the Breakout Cable
The vision system's I/O connector supplies connections for the acquisition trigger and
high-speed outputs.
Note:
I/O wiring or adjustments to I/O devices should be performed when
l
the vision system is not receiving power.
The Ethernet cable should be unplugged, or the PoE source powered
l
down before making adjustments to the connections at the far end of
the Breakout cable.
You can clip unused wires short or use a tie made of non-conductive
l
material to tie them back.
1. If installing the In-Sight 8405 vision system, attach the ferrite around the
Breakout cable, adjacent to the strain relief on the cable.
CAUTION:
standard components. To reduce emissions, the ferrite must be
attached to the Breakout cable.
2. Connect the Breakout cable's M8 connector to the vision system's I/O
connector.
3. Connect the trigger and high-speed I/O wires to an appropriate device (for
example, a PLC, trigger sensor or strobe light).
A ferrite is included with the In-Sight 8405 vision system
12