Cognex In-Sight 8000 Série Mode D'emploi page 20

8505P Vision System Specifications
Specifications
Class 3 Power over Ethernet (PoE) device.
Power
Power Type PoE Type A and Type B.
Power 12.95 W maximum per Class 3 PoE.
Consumption
Current Per Class 3 PoE requirements.
Voltage 48VDC nominal, applied from a Class 3 PoE source, which is typically powered from some
other voltage.
Case 0°C to 60°C (32°F to 140°F)
1
Temperature
Storage -20°C to 80°C (-4°F to 176°F)
Temperature
Humidity < 80% non-condensing
Protection IP40 with cables and lens attached.
1
To verify case temperature, use the EV GetSystemConfig("Internal.Temperature") Extended Native Mode
command or GetSystemConfig("Internal.Temperature") spreadsheet function. When issued, it returns the vision
system's internal temperature in degrees Celsius, which is ~3 degrees above the vision system case temperature.
®
Refer to the In-Sight Explorer Help file for more information. Additional cooling measures are required if the case
temperature cannot be kept below 60°C. Examples of such measures include: mounting the vision system to a heat
sink using the M3 mounting screws, reducing the ambient temperature and ensuring there is air flow over the vision
system.
Note: The In-Sight 8505P vision system must be connected to a Class 0, 3 or 4 PoE
power source, rated for at least 12.95 Watts. The CIO-MICRO I/O module is a Class 2
PoE device and therefore cannot be used to supply power to the In-Sight 8505P vision
system via the I/O module's PoE port.
8505P
19