Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Parts supplied
The display unit
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Installation using the screw holes
on the side of this product
1 Fasten the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three or four lo-
Truss head screw
cations on each side. Use either the truss
(5 mm × 8 mm)
head screws (5 mm × 8 mm) or flush surface
(6 pcs.)
screws (5 mm × 9 mm), depending on the
shape of the bracket's screw holes.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
screws supplied
with this product.
Dashboard or console
En
Chapter
03
17
Publicité
Chapitres
Table des Matières
