Handling And Storage; Handling; Storage; Installation - Saeco OFFICE One SUP028R Mode D'emploi

Installation of the machine - Service Provider Manual
9

HANDLING AND STORAGE

All the operations described in section 9 must be performed ex-
clusively by your service provider or a specialised technician,
who must organise all the operating sequences and use suitable
means to ensure strict compliance with current safety regulations.
9.1

Handling

During transport and handling, the machine must remain in an upright position
according to the indications shown on the packing container.
The machine must be lifted and positioned with care.
Do not shake it.
Make sure that nobody is standing within range of the load during
lifting and handling operations. In diffi cult conditions, additional
personnel should be assigned to oversee the manoeuvres to be carried
out.
9.2

Storage

The machine must be kept in the following storage conditions:
- minimum temperature: above 4°C.
- maximum temperature: below 40°C
- maximum humidity: below 95%
The machine is packed in cardboard containers with expanded polystyrene.
Warning. Given the total weight of the packing container, it is
forbidden to stack more than three machines. The machine
must be stored in its original packing in a NON-humid, NON-dusty
place.
10

INSTALLATION

All the operations described in section 10 must be performed
exclusively by the service provider or a specialised technician,
who must organise all the operating sequences and use suitable
means to ensure strict compliance with current safety regulations.
10.1

Safety rules

• Carefully read the entire instruction book.
• The connection to the mains power supply must be carried out in accord-
ance with the safety regulations in force in the user's country.
• The machine must be connected to a socket which is:
- compatible with the type of plug installed on the machine;
- suitably sized to comply with the ratings shown on the machine identifi -
cation plate.
- effi ciently earthed.
• The power cord must not:
- come in contact with any type of liquid: electric shock and/or fi re dan-
ger;
- be crushed and/or come in contact with sharp surfaces;
- be used to move the machine;
- be used if damaged;
- be handled with damp or wet hands;
- be wound in a coil when the machine is being operated.
- be tampered with.
• It is forbidden to:
- Install the machine outdoors and other than as directed in Section 10.
- Install the machine in areas where jets of water could be used.
- Disconnect the safety devices installed by the manufacturer.
- Use the machine in proximity to infl ammable and/or explosive substanc-
es.
- Leave plastic bags, polystyrene, nails etc. within children's reach, as
they are sources of potential danger.
- Allow children to play near the machine.
- Use spare parts not recommended by the manufacturer.
- Make any technical changes to the machine.
- Immerse the machine in any type of liquid.
- Wash the machine with a spray of water.
- Use the machine in any manner other than as directed in this instruction
• 38 •
book.
- Install the machine on top of other appliances.
- Use the machine in an explosive or aggressive atmosphere or where
there is a high concentration of dust or oily substances suspended in the
air;
- Use the machine where there is a potential fi re hazard;
- Use the machine to dispense substances that are incompatible with the
characteristics of the machine itself.
• Before cleaning the machine, make sure it is unplugged. Do not wash it with
petrol and/or solvents of any kind.
• Do not place the machine near heating equipment (like stoves or radia-
tors).
• In case of fi re use carbon dioxide extinguishers (CO
powder extinguishers.
10.2

Stop functions

The machine is stopped using the main switch.
10.3

List of supplied accessories

Manual: instructions for operating the machine.
Water hardness test: quick test for determining the actual hardness of the
water used to prepare beverages; this test is of fundamental importance for
setting the water hardness in the machine.
Key to access the water tank and access hatch to dispensing outlet: used
to prevent unauthorised personnel from accessing the water tank.
10.4

Installation-Siting

It is forbidden to install the machine outdoors or in places where
jets of water or steam are used.
The presence of magnetic fi elds or vicinity of electrical equipment
that generates disturbance may cause the machine electronic con-
trol system to malfunction.
Important.
With temperatures near 0°C, the internal parts containing water are
subject to freezing.
Do not use the machine in such conditions.
To ensure that the machine works properly and effi ciently, the following condi-
tions are recommended:
• room temperature: 10°C ÷ 40°C
• maximum humidity: 90%.
• the site should be duly prepared for installation of the machine;
• the machine should rest on a level, solid and fi rm surface; the surface the
machine rests on should incline by no more than 2°;
• the machine should be installed in an adequately lit, ventilated, hygienic
location and the electric socket should be within easy reach.
). Do not use water or
2