Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - Ninja BN642 Guide D'utilisation

USING THE SINGLE-SERVE CUP - CONT�
5 If using a pre-set program, first select the
program that best suits your recipe. The
pre-set feature will automatically stop
the appliance at the end of the program.
To pause the unit at any time, press the
currently active program a second time.
Refer to page 11 for program descriptions.
6 To remove the cup from the motor base,
turn the cup counterclockwise and then
lift it.
16 ninjakitchen.com
7 Remove the Pro Extractor Blades
®
Assembly by twisting the cap counter-
clockwise. DO NOT store blended
contents with Pro Extractor Blades
Assembly attached. Exercise care when
handling the blade assembly, as the
blades are sharp.
8 Unplug the unit when finished. To
release the motor base, place your hands
underneath both sides of the motor base
and gently pull the unit up and towards
you. Refer to the next page for storing
instructions.
9 To enjoy your drink on the go, place the
Spout Lid onto the Single-Serve Cup and
twist lid clockwise until firmly sealed. For
storing ingredients in the cup, use only the
Spout Lid to cover.
CARE & MAINTENANCE

CLEANING

Separate all parts. Wash all containers in
warm, soapy water with a soft cloth.
Hand Washing
Wash blade assemblies in warm, soapy
water using a dishwashing utensil with
a handle to avoid direct contact with
the blades. Exercise care when handling
blade assemblies as the blades are sharp.
Thoroughly rinse and air-dry all parts.
Dishwasher
All attachments are dishwasher safe. It is
recommended that the lids, containers,
and blade assemblies be placed on the
top rack of the dishwasher ONLY. Ensure
the blade assemblies are removed from
their containers before placing in the
dishwasher. Exercise care when handling
blade assemblies.
Motor Base
Turn off the unit and unplug the motor
base before cleaning. Wipe motor base
with a clean, damp cloth.
DO NOT use abrasive cloths/pads/
brushes to clean the base.

STORING

Wrap the power cord around the cord wrap
on the back of the motor base. Store the
unit upright and store all blade assemblies
inside or attached to their respective
containers with their lids locked into place.
DO NOT store blended or unblended
ingredients in the Single-Serve Cup with the
Pro Extractor Blades assembly attached.
®
DO NOT stack items on top of the
containers. Store any remaining attachments
alongside the unit or in a cabinet where they
will not be damaged or create a hazard.
RESETTING THE MOTOR
This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload the it. If the unit is overloaded, the
motor will be temporarily disabled. Should
this occur, follow the reset procedure below.
1 Unplug the unit from the electrical outlet.
2 Allow the unit to cool for approximately
30 minutes.
3 Remove the container's lid and blade
assembly. Empty the container and
ensure no ingredients are jamming the
blade assemblies.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.
So we may better assist you, please
register your product online at
registeryourninja.com and have the
product on hand when you call.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
visit ninjaaccessories.com.
ninjakitchen.com
17