Tristar KZ-2271 Mode D'emploi page 5

Before the firSt uSe
• To ensure the first cup of coffee tastes excellent, you should rinse the
coffee maker with warm water.
• Pull out the tank and pour water into it, the water level should not
exceed the "max" mark in the tank. Then replace the water tank.
• Place one of the filters into the filter holder (without coffee)
• Place an espresso cup on the removable shelf. Make sure the steam
control knob is in the "off" position.
• Activate the appliance by pressing down the on/off button, the power
indicator will illuminate.
• Press down the pump control button, the device starts pumping water,
when the water flows out stop the pump by pressing the pump control
button (the purpose of this step is pumping water out of the water
tank into the housing).
• Make sure the coffee/steam button is in the higher position and wait
until the heating indicator is illuminated, this indicates the preheating
is finished. Pressing the pump control button to the lower position, the
water will flow out.
• After this process you can start brewing.
• Note: there may be some noise when pumping the water the first time,
this is normal, the appliance is releasing the air in the appliance. After
about 20 seconds the noise will disappear.
Preheating
• To make a cup of good hot espresso coffee, we recommend you to
preheat the appliance before making coffee, including the filter holder,
and cup, so that the coffee flavor can't be influenced by the cold parts.
• For preheating please follow the same steps as described in the
paragraph "before the first use".
KZ-2271_IM_V2.indd 5
Make eSPreSSo coffee
• Remove after preheating the filter holder by turning it clockwise, add
ground coffee in the filter by using the supplied spoon. One spoon
ground coffee can make about a cup of top grade coffee. Press the
ground coffee powder tightly with the tamper.
• Place the filter into the filter holder, make sure the handle of the filter
holder aligns with the groove in the appliance, then insert the filter
holder into the appliance and turn it anticlockwise until it's in the lock
position with the handle pointing forward.
• Pour out the hot water from the preheating process and replace the
cup under the appliance.
• When the heating indicator illuminates you should press down the
pump control button to the lower position, now the coffee will flow out.
• Note: if the heating indicator is extinguished please press the pump
control button to stop making espresso. After a few seconds, when the
heating indicator illuminates again you could resume the pump process.
• When you've obtained the desired amount of coffee or the color
changed weak, please press the on/off button, the power indicator will
extinguish and the coffee maker stops working, your coffee is ready now.
• Note: do not leave the coffee maker unattended during making coffee,
sometimes you need to operate manually.
• After finishing making the coffee, please take out the filter holder, lock
the filter, and pour out the coffee residue.
frothing Milk/ Make caPPuccino
• You get a cappuccino when you top up a cup of espresso with frothing
milk.
• Press down the coffee/steam button to the lower position which is the
steam position, wait until the heating indicator illuminates.
Coffee maker
EN
5
15-3-2013 15:51:27