Start-Up Sequence - effegibi aquasteam Manuel D'utilisation Et D'entretien

OPERATING AND MAINTENANCE MANUAL FOR AQUASTEAM,
4.1

START-UP SEQUENCE

The purpose of the start-up sequence is to synchronise all the installed elements (generator, control panel,
lighting).
Once this sequence has been run, all the functions of your Hammam/Turkish bath will be easy to run from the
control panel.
The start-up sequence must be run the first time the AQUASTEAM MAXI steam generator is run up.
You only need to run the start-up sequence for the AQUASTEAM/EASYSTEAM models if an external control
panel or light fitting is added.
Please note that the start-up sequence need only be repeated after additional optional EFFEGIBI features
have been added at a later date.
Make sure that the steam generator is connected to the electricity and water supplies.
If there is also a second optional external panel, the start-up sequence must only be run from the
Aquasteam/Aquasteam Maxi/Easysteam steam generator.
Switch on the panel by pressing the "ON/OFF" button (fig. A).
fig. A
The panel will display all the icons with a dimmer light. The control icons will flash, buttons "B" and "C" and
the Effegibi logo will appear with a brighter light (see fig. B).
fig. B
Press the temperature controls, buttons "C" and "A", firmly and in rapid succession, and they will glow
brighter, and then the "ON/OFF" button. In fig. C, the sequence is shown as numbers "1", "2" and "3".
The "ON/OFF" button (shown as number "3") must be pressed firmly for a few seconds until all the control
panel buttons have been flashing.
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes without having to give prior warning or replace this manual. The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes without having to give prior warning or replace this manual.
AQUASTEAM MAXI, EASYSTEAM
A C
B
EN
37