Using An Ac Adaptor (Optional); Connecting The Pk-6 To An External Instrument With Its Pk Cable - Roland PK-6 Mode D'emploi

3.
Press the [OCTAVER BASS/DOWN] or [POR-
TAMENTO/UP] footswitch to select the "Bat"
parameter.
4.
Press the [ENTER] pedal to confirm.
The display shows the battery status from 0 to 100.
"100" means full charge, "0" means that you need to
replace batteries right away.

Using an AC adaptor (optional)

The PK-6 can also be powered with an optional PSB-1U
adapter.
NOTE
Be sure to use only the AC adaptor recommended for the PK-6
(PSB-1U). Also, make sure the line voltage at the installation
matches the input voltage specified on the AC adaptor's body.
Other AC adaptors may use a different polarity, or be designed
for a different voltage, so their use could result in damage,
malfunction, or electric shock.
1.
Connect the power cord to the optional AC
adaptor.
To the PK-6's DC IN connector
AC adaptor
Indicator
Place the AC adaptor so the side with the indicator
faces upwards and the side with textual information
faces downwards.
The indicator will light once you plug the AC adaptor
into a wall outlet.
Power cord
To an AC outlet
Dynamic MIDI Pedal PK-6
2.
Connect the optional AC adaptor to the
PK-6's DC IN socket.
To a wall outlet
3.
Plug the power cord into a power outlet.
Connecting the PK-6 to an external
instrument with its PK cable
Use the PK cable that is supplied with the PK-6 to con-
nect the external instrument and PK-6. This connection
system will allow the external instrument to power the
PK-6 (so that you don't need batteries or an optional
adaptor).
The PK-6 will be turned on/off by the power switch of
the external instrument, regardless of the position of
the PK-6's own power switch.
1.
Make sure that the external instrument's
power is turned off and the volume is mini-
mized.
2.
Use the PK cable that is supplied with the
PK-6 to connect the external instrument's
PK IN connector to the PK-6's PK OUT con-
nector.
Once everything is properly connected, be sure to fol-
low the procedure below to turn on their power. If
you turn on equipment in the wrong order, you risk
causing malfunction or equipment failure.
3.
Turn on the power of the external instru-
ment and adjust the volume as explained in
the its owner's manual.
4.
Check whether the PK-6 is on as well.
r
Using an AC adaptor (optional)
C-200
(Other compatible instruments
are: Roland AT-350C, AT-900C,
V-Combo, etc.)
11