Midi Transmit Channels - Roland PK-6 Mode D'emploi

The following message appears for a few seconds:
C00
It means that the PK-6 expects you to input a value
for the CC00 (MSB) message.
NOTE
If you only need to enter a PC value (because the previous
CC00 and CC32 values are the same), press the [MIDI CON-
TROLLER/PG] footswitch twice to skip the "C00" and "C32"
pages and proceed to step (7).
3.
Use the pedals labeled [0]~[9] to enter the
CC00 (MSB) value.
The value you entered flashes.
16
Example: To set the CC00 value to "16", press the [1]
and [6] pedals.
NOTE
If you pressed the wrong pedal while specifying the num-
ber, you can cancel your input by pressing [CANCEL] pedal.
NOTE
You can also use the [DOWN] and [UP] footswitches to
decrement/increment the value shown in the display.
NOTE
If you entered a value higher than "127" for the CC00 mes-
sage, the PK-6 automatically corrects it to "127" when you
press the [ENTER] pedal.
4.
Confirm by pressing the [ENTER] pedal.
The following message appears for a few seconds:
C32
It means that the PK-6 expects you to input a value
for the CC32 (LSB) message.
5.
Use the pedals labeled [0]~[9] to enter the
CC32 (LSB) value.
Dynamic MIDI Pedal PK-6
The value you entered flashes.
NOTE
If you entered a value higher than "127" for the CC32 mes-
sage, the PK-6 automatically corrects it to "127" when you
press the [ENTER] pedal.
6.
Confirm by pressing the [ENTER] pedal.
The following message appears for a few seconds:
PC
The PK-6 now expects you to input a program
change value.
7.
Use the pedals labeled [0]~[9] to enter the
PC value.
The value you entered flashes.
NOTE
If you entered a value higher than "127" for the PC mes-
sage, the PK-6 automatically corrects it to "127" when you
press the [ENTER] pedal.
8.
Confirm by pressing the [ENTER] pedal.
The PK-6 now transmits the memory selection cluster
(CC00, CC32 and PC) and immediately leaves Shift
mode.

MIDI transmit channels

This setting specifies the MIDI channel on which the
PK-6 will transmit.
MIDI uses sixteen "MIDI channels," which are numbered
1 through 16. By connecting MIDI devices and spe-
cifying the appropriate MIDI channel for each device,
you can play and/or select sounds on those devices.
The PK-6 allows you to select different MIDI channels
for the following modes: MONO, POLY, DRUM, and MIDI
CONTROLLER.
Function Value Default
MIDI channel 1~16 MONO mode= 2
POLY mode= 11
DRUM mode= 10
MIDI CONTROLLER mode= 10
1.
Select the mode whose MIDI channel setting
you want to change.
Press the appropriate footswitch: MONO, POLY,
DRUM, or MIDI CONTROLLER.
2.
Press the [SHIFT] footswitch to activate
Shift mode (secondary footswitch func-
tions).
r
MIDI transmit channels
0
21