Publicité
Les langues disponibles
Les langues disponibles
tioned within the area of the sink, otherwise
escape of water can lead to serious flooding
to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is not
too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the
product. Keep all the safety advice and instruc
tions in a safe place for future reference!
Installation
Installing the tap
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in Fig. A–B.
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material dam
age could result.
Flushing the tap
The tap must be flushed through before first use
to remove any dirt. To do this, follow these
steps (see Fig. C):
Screw the mixer nozzle
Open the main water supply and allow the
water to run for two minutes.
Then screw the mixer nozzle
Water-saving function
The cartridge
in this tap has an EcoClick
13
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. F).
10 GB/IE
off.
7
on again.
7
Lift the lever
until you notice a slight resist
8
ance. This resistance will cause a stop in case
of partial opening and will therefore simply limit
the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
resistance.
Energy-saving function
The cartridge
in this tap has an energy
13
saving function.
Only cold water will flow out when the control
lever
is set to the middle position, and thus
8
reduce energy comsumption (see fig. G).
Operation
Bringing into use
Note: If the tap has not been used for a long pe
riod flush the pipes through thoroughly in order to
avoid stagnation and buildup of residues in the
drinking water supply.
Open the main water supply.
Lift the control lever
or left in order to regulate the speed or temper
ature of the water flow.
Setting the temperature limiter
The cartridge
in this unit has a temperature
13
limiter. This function is not activated in the factory
(neutral setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig D. to set the temperature limitation.
Turn off the main water supply.
Remove the plastic cover
small flat screwdriver.
Release the locking screw
clockwise using the Hexagonal key
until you overcome the
8
and swing it to the right
8
carefully by a
10
by turning it anti
9
.
16
Publicité
