American Dynamics Illustra 625 PTZ Guide De Référence Rapide page 17

Note
Push the microSD card into the memory card slot until it locks into position.To
remove the microSD card push the card gently until it disengages from the dome.
Remove the microSD card.
11 Attach the bubble assembly:
a Remove the bubble assembly from the packaging.
b Attach the plastic lanyard on the housing to the screw on the inside of the trim ring of
the bubble assembly.
c It may be necessary to orientate the plastic lanyard to the position shown in Figure 9.
This will ensure that the plastic lanyard does not become trapped between the bubble
assembly and the camera housing and will aid with alignment.
d Align the bubble assembly with the holes on the outdoor housing flange. The location
ribs on the trim ring will fit between the fins on the outside of the housing as seen in
Figure 10.
English Illustra 625 PTZ Outdoor Housing
Figure 8
Figure 9
7