Scope Of Delivery; Initial Operation - Metabo BFE 9-90 Notice Originale

ENGLISH
ENG
Pull the plug out of the plug socket before any
adjustments, conversions or servicing are
performed.
The rated speed of the sanding belt must be at
least equal to the belt speed in idling marked on
the power tool. A sanding belt running faster than
its rated speed can break and fly apart.
Check prior to each use that the sanding belt is
correctly attached and is completely on the rollers.
Carry out a trial run: Allow the machine to run at
idling speed for 30 seconds in a safe location. Stop
immediately if significant vibrations occur or if
other defects are noted. If such a situation occurs,
check the machine to determine the cause.
5 Overview
See page 2.
1 Sanding attachment
2 Rotary knob for securing the sanding
attachment and adjusting the belt run
3 Cover
4 Arrow (direction of rotation of drive shaft)
5 Screw for securing the cover
6 Sanding belt
7 Tensioner arm for replacing the sanding belt
8 Sanding head
9 Locking screw for adjusting sanding head
10 Additional handle
11 Sliding switch
12 Adjusting wheel for setting belt speed

6 Scope of delivery

The machine is also available with different acces-
sory parts. An overview can be found on page 4.
Subject to change.
A Sanding belt arm
B Sanding belt, zirconia alumina
C Nylon web band
D Microfibre cloth
E Stainless steel cleaning spray

7 Initial Operation

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your power
supply.
10
Attaching the additional handle
Always work with the additional handle
attached (10)! Attach the additional handle
on the left or right of the machine and secure.
Attach the additional handle to the side facing
away from the sanding belt (6).
Turning the sanding head (8) to operating posi-
tion
Loosen the locking screw (9) using the hexagon
spanner and, if necessary and depending on the
task at hand, turn the sanding head (8). The
sanding head must be positioned in the permitted
working area as shown (see illustration A, page 2).
Firmly tighten the locking screw (9).
Each time before you start work, verify that
the locking screw (9) is sufficiently tightened
to ensure that the sanding head (8) does not move.
Otherwise, the sanding belt (6) may come in
contact with the user. Loss of control can cause
personal injury.
8 Use
8.1 On/Off switch, continuous activation
Always guide the machine with both hands.
Switch the machine on first before mounting
it on the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits.
After switching off the machine, only place it
down when the motor has come to a stand-
still.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from the
mains socket or if there has been a power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine using
the handles provided, stand in a safe position and
concentrate.
11
I
Switching on/Continuous activation: Push slide
switch (11) forward. For continuous activa-
tion, now tilt downwards until it engages.
Switching off: Press the rear end of the slide
switch (11) and release.
0