Manuels Connexes pour Kyocera JS-700
Sommaire des Matières pour Kyocera JS-700
- Page 1 INSTALLATION GUIDE FOR JOB SEPARATOR GUIDE D’INSTALLATION DU SEPARATEUR DE TRAVAUX GUIA DE INSTALACION PARA SEPARADOR DE TRABAJOS INSTALLATIONSANLEITUNG FÜR JOBTRENNER GUIDA ALL’INSTALLAZIONE DEL SEPARATORE 作业分离器安装手册 ジョブセパレータ設置手順書 JS-700...
- Page 3 × Procedure E TP screw M3 05 ..........1 English Caution: When installing a job separator, be sure to turn the MFP main switch off and Supplied part disconnect the MFP power plug from the wall A Job separator..........1 outlet. B LED PCB ............
- Page 4 1. Insert the LED PCB (B) into the job separator 4. Open the hook (7) on the right side and 2. Open the left transfer cover and the front (A). remove the left front cover (8). cover. 3. Remove the staple holder (4), remove the Connect the 2-pin connector (2) of the job two screws (5) from the upper side and the separator (A) into the 2-pin connector (1) of...
- Page 5 5. Remove the two screws (9) and remove the 6. Remove the two screws (11) and then 7. If the branch pressure lever (13) on the rear ejection cover (10) with the mounting plate. remove the inner ejection cover (12). side of the job separator (A) has lowered, raise it.
- Page 6 8. Insert the job separator (A) into the MFP from the front side and slide it to the left. Secure the rear 9. Connect the connector (15) of the job side using a pin (14) and the front side using a TP screw M3 05 (E).
- Page 7 10. Attach the job separator tray (C) to the rail (17) of the job separator (A) by sliding it from the front side. Insert the fitting section (18) on the right side of the job separator tray (C) into the recessed portion (19) of the MFP.
- Page 8 11. Release the three tabs (23) of the left front cover (8) that has been removed in step 4 to remove 12. Fit the left front cover JS (D) using the two the white right side section (22), and fit the left front cover JS (D). screws (6) on the left side to secure and using the two screws (5) that have been removed in step 3.
- Page 9 13. Refit the staple holder that has been Operation check 3. Make a test copy to check that a copy is removed in step 3 to its original position and 1. Insert the power plug of the MFP into an ejected to the job separator tray (C).
- Page 10 MEMO...
- Page 12 2005. 12 303KB56710 Rev.1.0...