Quick SBC NRG+ Série Manuel D'installation page 11

NECESSARY EQUIPMENT FOR INSTALLATION
Use the batteries and cables on the output terminals as specified in the following table:
MODEL
Battery voltage
Battery capacity
Minimum output cable size
Number of battery cells
The cables connected to the output terminals have a maximum length of 4 metres.
WARNING: the battery charger must be used only with re-chargeable lead/liquid electrolytic batteries (open or
sealed), Gel, AGM, Optima
WARNING: the battery charger can not be used to recharge non rechargeable batteries.
INSTALLATION SITE
Install the battery charger as close as possible to the batteries in a dry and airy spot, to allow the correct operation of
the device at full power.
The battery charger can be installed on a horizontal surface or vertical wall paying attention that the output connector
faces downwards.
The battery charger must be fixed to the support surface with screws strong enough to support its weight, paying atten-
tion that they do not weaken or cause cracks to the boat structure.
Vertical installation is recommended since the natural convection of the heat will favour the cooling of the device.
The perimeter of the battery charger (excluding the support base) must be kept at a distance from walls or objects by a
minimum of 5 cm.
+
SBC NRG MINI LOW REV000A
SBC 140 NRG+ FR SBC 250 NRG+ FR
55 ÷ 120 Ah 110 ÷ 250 Ah
6 mm 10 mm
2
.
®
5 cm
SBC 300 NRG+ FR
12 V
140 ÷ 300 Ah
10 mm
2 2
6
5 cm
5 cm
OPT OL
AGM SL
GEL
5 cm
INSTALLATION
SBC 500 NRG+ FR SBC 365 NRG+ FR
180 ÷ 400 Ah 65 ÷ 150 Ah
16 mm 6 mm
2
EN
24 V
2
12
11