Water Hardness Setting; Safety Blocking - ROSIERES RFV460EIX Manuel D'instruction

EN
Basic settings

Water Hardness setting

The appliance
automatically indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range of
water hardness (see table below).
Type
Soft water
Medium water
Hard water

Safety blocking

The oven functioning can be blocked (for example, to stop it being used by children).
1. To block the oven, press the Start/Stop key for
3 seconds. You will hear a sound signal and
the display will show the word "SAFE". The
oven is blocked in this state and cannot be
used.
33
features a system
Ca + Mg English deg.
(ppm)
0 to 150
151 to 350
501 to 500
that To set the water hardness parameter, proceed as
follows:
1. Press the Start/Stop key and the Function
selection key simultaneously. The hardness
number will start to flash on the display (not
necessary if your oven is first plugged in or
after a power failure).
2. Turn the rotating knob to set the correct water
hardness parameter value, according to the
below table.
3. Press the Clock key to set the parameter. The
display shows the clock.
Water hardness
French deg.
[°eH] [°dF]
0 to 11 0 to 15
12 to 25 16 to 35
26 to 35 36 to 50
2. To unblock the oven, press the Start/Stop key
again for 3 seconds. You will hear a sound
signal and the display will show the clock
again.
The clock can be seen by pressing briefly the
Start/Stop key.
German deg.
Display
[°dH]
0 to 8
9 to 20
21 to 28
1
2
3