Publicité
Les langues disponibles
Les langues disponibles
6
7
Installation of wiring connection
Switch off the dedicated power supply to the
hood.
Remove the wiring electrical knockout using a
Cable through the electrical knockout.
Connect the Power Supply Cable to the ran-
gehood. Attach the White lead of the power
supply (A) to the White lead of the rangehood
(D) with a twist-on type wire connector. Attach
the Black lead of the power supply to the Black
lead of the rangehood (B) with a twist-on type
wire connector (C). Connect the Green (E)
(Green and Yellow) ground wire under the
Green grounding screw.
Connect the ductwork to the damper and seal
all connections with duct tape.
Turn the power supply on. Turn on the blower
and light. If the rangehood does not operate,
check that the circuit breaker is not tripped
or the house fuse blown. If the unit still does
not operate, disconnect the power supply and
check that the wiring connections have been
made properly.
Hook the Grease rail (8) positioning it inside
the hood. It is possible to wash and reposition
the rail inside the hood.
8
Hood wiring
23
Publicité
