Rane RM6 Guide D'utilisation page 5

Setup
Items not listed under
To set up RM6 with your sound system:
1. If you are using microphones or other audio sources that send a line-level signal, connect
them to the mic/line inputs on the rear panel.
2. Use standard XLR cables to connect the line outputs on the rear panel to your
loudspeakers, remote mixer, etc.
3. Use the included power cable to connect RM6 to a power outlet.
4. Power on all of your audio sources (Blu-ray players, stereos, microphones, etc.).
5. Power on RM6.
Example
Power
Loudspeakers
Introduction Box Contents are sold separately.
Microphones
5