Installing Your Beverage Center; Unpacking Your Beverage Center; Leveling Your Beverage Center; Proper Air Circulation - Haier HC125FVS Guide De L'utilisateur

English

Installing Your Beverage Center

Unpacking Your Beverage Center

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the beverage center accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the beverage center.

Leveling Your Beverage Center

• Your beverage center has leveling legs which are located at the
bottom of your beverage center. After properly placing your beverage
center in its final position, you can level your beverage center.
• Leveling legs can be adjusted by turning them clockwise to raise your
beverage center or by turning them counterclockwise to lower your
beverage center. The beverage center door will close easier when the
leveling legs are extended.
• Also, there is an adjustable support for the lower door hinge. (see
fig.4) After leveling the Beverage Center, adjust the hinge support, up
or down as needed until it rests on the surface on which that unit is
placed.

Proper Air Circulation

• To assure your beverage center works at the maximum efficiency it
was designed for, you should install it in a location where there
is proper air circulation and electrical connections.
• The following are recommended clearances around the beverage
center:
Sides...............3/4 "(19mm)
Top....................2" (50mm)
Back..................2" (50mm)
5