Install Air Filter
(on some models)
An air filter is 15 times more powerful than baking soda at
reducing common food odors inside the refrigerator.
On some models, your refrigerator's accessory packet includes
an air filter, which must be installed prior to use.
Installing the Air Filter
Install the air filter behind the vented door, located on the rear wall
near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.
A
Installing the Filter Status Indicator
The filter comes with a status indicator which should be activated
and installed at the same time the air filter is installed.
1. Place the indicator facedown on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator until
the bubble pops to activate the indicator.
3. Lift open the vented air filter door. On some models, there are
notches behind the door.
16
16
16
16
16
16
A. Air filter
Models with notches:
■
With the indicator screen facing outward, slide the
indicator down into the notches.
NOTE: The indicator will not easily slide into the notches
if the bubble has not been popped.
■
Close the air filter door, and check that the indicator is
visible through the window in the door.
A
B
C
A. Status indicator window
B. Air Filter status indicator
C. Notches
Models without notches:
■
Place the indicator somewhere it is easily visible - either
inside the refrigerator or elsewhere in your kitchen or
home.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months when
the status indicator has completely changed from white to red.
To order a replacement air filter, contact us. See "Accessories"
in the User Guide, Use and Care Guide, or User Instructions for
information on ordering.
1. Remove the used air filter by squeezing in on the side tabs.
2. Remove the used status indicator.
3. Install the new air filter and filter status indicator using the
instructions in the previous sections.