Introduction - SciCan HYDRIM M2 Mode D'emploi

1. Introduction

Thank you for selecting the Hydrim M2 instrument washer-disinfector. The Hydrim
M2 is designed in accordance with the ISO15883-1 and -2, the European standards
for washer-disinfectors. The Hydrim complements the Statim autoclaves by quickly
and hygienically preparing soiled instruments for sterilisation. To ensure years
of safe, trouble-free service, carefully review this Operator's Manual before operating
the unit. The Hydrim M2 is suitable only for the applications listed in this manual.
Using the Hydrim for other purposes may be dangerous. The manufacturer cannot
be held responsible for damage caused by improper use.
Operational, maintenance and replacement instructions must be followed for the
product to perform as designed. All trademarks referred to in this manual are the
property of their respective owners. Contents of this manual are subject to change
without notice to reflect changes and improvements to the Hydrim product.
The Hydrim M2 should only be installed and serviced by a qualified contractor as it
is an Installation Category 2 device. Before connecting the unit, the installer should
check that the voltage and frequency of the electrical supply correspond with the
details in the installation instructions. The unit must only be plugged into a grounded
outlet. Please note that this unit is completely isolated from the electrical supply only
when it is unplugged or the circuit breaker is turned OFF. This must be done before
any repair work is carried out.
The Hydrim M2 uses HIP™ Cleaning Solution exclusively. The unit will not perform
as described if other detergents / cleaning products are used. Other detergents /
cleaning products may damage the unit, the instruments, cause excessive foaming,
and void the warranty. Do not use solvents in this unit. Do not allow small children or
unauthorised personnel access to this unit or its controls.
32