Table des Matières
Publicité
WINDING BOBBIN
Be sure to use Class 15 J bobbins.
1. Place a spool of thread on the spool pin, and secure it
with the spool pin cap. Pull the thread out from the spool
through thread guide.
2. Pull end of thread through hole in bobbin as shown.
3. Push bobbin winder shaft to the far left position, if it is not
already there. Place bobbin onto shaft with end of thread
coming from top of bobbin. Push bobbin winder shaft to the
right until it clicks. Hold onto end of thread.
4. Start machine. Bobbin will automatically stop turning when
completely filled. Push shaft to the left to remove bobbin
and cut thread.
14
1
1
2
3
4
Publicité
Table des Matières
