Symbols Used; Operating Elements; Control Panel; Mig/Mag 150/20 Xt - Metabo MIG MAG 165 SP Instructions D'utilisation

ENGLISH
For shielded gas welding it must be
ensured that the shielding gas cover is
not blown away by air draft.
For machine performance see "Techni-
cal Specifications".
Any other use is not as specified and
prohibited.
The manufacturer does not assume any
liability for damage caused by unspeci-
fied use.
2.2

Symbols Used

Danger!
Disregard of the following
warnings could
serious personal injury or
material damage.
Read operating instruc-
tions before initial opera-
tion
2-step mode
4-step mode
Spot welding
Gasless and
wire thread-up not applica-
ble for: MIG MAG 165 SP
MIG MAG 150/20 XT
Wire feed speed
Welding current coarse set-
ting (voltage)
Welding current fine setting
(voltage)
Supply voltage
Welding machine suitable
for welding
ments with an increased
electrical hazard.
Excess temperature
Information on the name plate:
1
2
3
8
12
1 Manufacturer
2 Machine designation
3 Serial number
4 Standard information – This
machine meets the requirements
of the standards mentioned
5 CE mark – This machine con-
forms to EC directives as per
declaration of conformity
6 Waste disposal symbol – the
machine can be disposed of
cause
through the manufacturer
7 Electrical performance data
8 Date of manufacture

3. Operating Elements

3.1

Control Panel

9
currentless
in environ-
9
10
4 5
11
12
6
7
10 11 12
Operating mode selector
switch
To set the operating mode.
LED overload (yellow)
Indicates overloads.
LED power (green)
Indicates the welding
machine's readiness for opera-
tion.
Wire feed setting knob
For setting the wire feed speed.
Setting range: approx. 0 to 20
m/min
(On the MIG/MAG 150/20 XT
the wire feed speed depends
on the set welding step as
well).
13 Weld time setting knob
For setting the weld time in
spot weld mode.
Setting range: approx. 0 to 15 s
3.2

MIG/MAG 150/20 XT

17
16
14 Welding gun
13
(not detachable)
15 Earth cable (cross
section = 16 mm
16 Main switch
Position I: machine turned ON
Position 0: machine turned
OFF
17 Welding step selector switch
Switches the welding current
(voltage) in six steps.
3.3

MIG/MAG 165 SP

21
20
18 Connector for welding gun
Accepts all commercially avail-
able welding guns (Euro con-
nector KZ-2).
14
15
2
)
18
19