Qlima PGU 2013 Manuel D'utilisation page 45

man_PGU2013 ('20).indd 45 man_PGU2013 ('20).indd 45
ASSEMBLY (picture 2)
Required tools
• Open end wrench 10 & 13 mm
• Adjustable opening wrench (2) 20 cm (8'') long
• Slip joint pliers 23 cm (9'') long
• Philips screwdriver w/ medium blade
• PIumbing tape for joints
• Spray bottle of soap solution for leakage test
Parts supplied
• Stand (1) with tank housing (8)
• Assembly post (7) with 3 pcs post brackets
• Gas connector suitable for:
- Ø 8-12 mm hose (all EU countries except France)
- G1/2'' (France only)
• Note: Hose and regulator not included
• Reflector 820 mm consisting out of 4 pieces with:
- 9 pcs washers Ø 8 mm
- 9 pcs M6*10mm bolts
- 9 pcs M8 cap nuts
• 3 pcs 60 mm pins for reflector support
• 4 pcs bolts M6 X 10 mm for assembly post and burner
• 6 pcs bolts & nuts M6 X 35 mm for post and post brackets
• 3 pcs bolts M8 X 16 mm for post brackets and stand
• Bracket with 2 wheels including:
- 2 bolts M8*20
- 2 nuts M8
Step 1a: picture 12
To protect heater from strong wind, anchor the base securely to the ground with
screws.
• Reverse the base, fix the ground fixer to the base with bolts and washers like
picture shows.
• Secure the ground fixer with nuts.
• Fix another two ground fixer with bolts and nuts, and reverse the base.
Step 1b: picture 3
• Put the 3 pcs post brackets (9) on each position on the base (10) as shown in
picture 2.
• Use 3 pcs M8 x 16 mm bolts to join the post brackets (9) and base (10).
Step 2: picture 4
• Put the post (7) on the top of 3 pcs post brackets (9).
• Use 6 pcs M6 x 35 mm bolts and nuts to connect the post (7) to the 3 pcs post
brackets (9). Tighten the bolts and nuts.
Step 3: picture 5
Step 4: picture 6, 7, 8
• Secure the 3 pcs 60 mm pins (reflector support bolts) on the cap of flame
screen (2).
• Connect the gas hose (QA1) to the gas connector. (picture 7)
4
45
18-05-20 12:49 18-05-20 12:49