Instructions For Use - Philips SBC RU 098 Mode D'emploi

Instructions for use

3. Press y 6 to stop the search.
–The LED stays lit.
Note: if y has been pressed too late,
– Turn on the TV again manually
– Press P - 2 to test previous codes until the TV turns off again
4. Press y 6 to lock the code.
– The indicator LED blinks twice to indicate successful set-up.
Notes
– Turn on the TV again and press the SBC RU 098's buttons to see if they are
working as expected. Some codes are quite similar. If your TV does not
respond correctly, repeat steps 1 to 4 to find a better code.
– Maximum search time is 8 minutes for a TV.
READING OUT THE 5-DIGIT BRAND CODE
After using Autosearch to set up the SBC RU 098, note the code for future use.
1. Press and hold c 5 and y 6 at the same time for 3 seconds.
– The indicator LED lights up.
2. Press c 5.
– The LED indicator goes out.
3. Press P + 1:
– The indicator starts to blink; Count the number of blinks for the first digit.
Note: if the indicator does not blink, the digit is 0.
4. Press P - 2
– The indicator starts to blink; Count the number of blinks for the second
digit.
5. Press + 3.
– The indicator starts to blink; Count the number of blinks for the third digit.
6. Press 4.
-
– The indicator starts to blink; Count the number of blinks for the fourth
digit.
7. Press c 5.
– The indicator starts to blink; Count the number of blinks for the fifth digit.
8. Write down the code inside the SBC RU 098's battery lid.
Also available from Philips universal remote controls that fit your needs.
Look for the unique full range of universal remote controls from Philips at a retailer near
you.
RU 410: 1 in 1 Universal Remote Control - digits and teletext
RU 422: 2 in 1 Universal Remote Control for TV and VCR
RU 430: 3 in 1 Universal Remote Control for TV, VCR and SAT-receivers
RU 440: 4 in 1 Universal Remote Control for TV, VCR, SAT-receivers and Audio
RU 455: 4 in 1 Universal Remote Control for TV, VCR, SAT-receivers and a second device,
with backlit keys
RU 460: 6 in 1 Universal Remote Control- Pre-programmed and Learnable
Also available: the SBCLI510 remote control extender set, this system allows you to operate
every IR driven equipment from anywhere in or around the house. You do not have to 'see'
the equipment that you want to control anymore, nor do you have to aim the remote control
on your equipment.
RU 098/00- page 5
5