iKarus ECO 7 Manuel D'utilisation page 35

6. REMOVAL AND CHANGING SERVOS
Roll servos front right and left
Pull servo plug off of electronics (remember servo plug location). Remove servo pushrod
from swash plate, unlock the servo by pushing it in arrow direction and remove it from
the mechanics (see "Servo installation" on previons page)
Forward pitch servo
Pull servo plug off of electronics (remember plug location), detach servo pushrod from
the swash plate and remove servo from the mechanics by pushing pins together.
· Pull servo plug off of electronics
· Detach servo pushrod from swash plate and remove swash plate
· Unlock holding clamps by applying pressure in direction of the arrow
· Pull out servo
· Take off holding clamps
Servo assembly and adjustment
If servos are installed or replaced, the trimming memory should be purged and then the servos should be readjus-
ted (See Chapter IV).
After replacing a servo, the center position must be newly adjusted and saved in the GigaTronic memory.
This is vital for the pitch and throttle curves to remain unchanged.Proceed as outlined in Chapter IV. Adjust
the servos in such a way that the ring of the swash plate is positioned all way around approx. 1mm below the edge
of the guide ring.
34
���