iKarus ECO 7 Manuel D'utilisation page 32

V. V. V DISASSEMBLING AND MAINTENANCE
1. DISASSEMBLING THE ROTOR HEAD
In order to be able to disassemble the mechanics, the
rotor head must be separated from the rotor shaft fi rst.
Here, fi rst remove the rotor blades using the proper tools.
Remove the Hiller pushrods from the ball of the fl ybar.
Remove the rotor head holding screw M2 x 12 and both
self-tapping screws 2.9 x 9.5. You can now pull the rotor
head off the main rotor shaft.
1.Unhook Hiller pushrod
2.Loosen screw
3.Pull off rotor head
2. DISASSEMBLING SKID LANDING GEAR
Next, pull the antenna out of the antenna tube near the
skid landing gear and push the skid landing gear struts
out of the chassis holding rails in order to extract them.
1.Using a screwdriver leverage skid landing
gear struts out of the holding rails in the front
and in the rear .
2.Remove skid landing gear.
3. REMOVING THE MECHANICS
By applying pressure (from above), you can now take
out the mechanics from below. While doing this, pay
attention to the cable connecting the tail motor and
pull it off.
1.Carefully pull mechanics a little out of the
fuselage.
2.Disconnect tail motor plug; extract mechanics.
��
��
��
��
��
��
�� � ��
��
��
31