Adjustment Procedure - iKarus ECO 7 Manuel D'utilisation

Programming:
• Plug in receiver battery. LED fl ashes red.
• Push both transmitter control sticks into any corner and hold.
• Turn on transmitter; wait for "CONFIRM."
• Release control sticks and move pitch to minimum position; "CONFIRM."
• Tail stick all the way to the right; "CONFIRM," release tail.
• Pitch forward stick all the way to the front; "CONFIRM," release pitch forward.
• Roll stick all the way to the right; "CONFIRM," release roll.
Optional:
• Switch Flight phase to Acro; "CONFIRM," back to normal.
• Three-position switch Mode to setting Heading Lock; "CONFIRM," back to motors Off.
• Successively toggle additional switches; "CONFIRM," back.
• Set Pitch all the way to the front and back again, long "CONFIRM."
Programming fi nished, (Signal: disconnected); LED fl ashes green. Programming fi nished, (Signal: disconnected); LED fl ashes green.
Adjusting swash plate
This operation is useful if the servos have been replaced. With roll (right, center, left) the servo is chosen, with for-
ward pitch the zero setting is changed.
Preparation:
• Center all transmitter trimmers.
• Turn off transmitter.

Adjustment procedure:

• Plug in receiver battery. LED fl ashes red.
• Push forward pitch and roll sticks to any side and hold.
• Turn on transmitter; wait for "CONFIRM."
• Set pitch to maximum; wait for "CONFIRM."
• Pre-select with roll servo (Right, Center, Left)
• Change zero position with forward pitch (full defl ection) until the swash plate stands horizontal and at the
correct height.The center of the adjustment range is displayed with "CONFIRM."
• Pitch to minimum fi nishes adjustment and saves the new settings.
After this adjustment the model must be retrimmed, for this purpose erase model trimming fi rst.
Pitch/
Throttle
Phase
Yaw
Roll
Forward
Pitch
Model
Function
30
GigaTronic System Flow Chart
Shaft governor
Akro
Throttle
Acro
Hover
Pitch-curve
Acro
Throttle Curve
composation
Hover
Tail- curve
Tail stick
Acro
effect
Hover
Mode
Roll-curve
Akro
Hover
Head
system
Forward Pitch
Curve Acro
Hover
Acro
Programmed curves
Hover
Soft
start
Throttle effect
Throttle change
Gyro sensitivity
Heading sensitivity
Load change effect
Heading intensity
Load change duration
Heading fade out
Holding range
Gyro effect
Feedback control
Acro Heading-mode
Shaft governor
Gyro - Mode
Hover
Main motor
/ Throttle
servo
Tail mixing
Tail start setting
/ Combi tail setting
Tail motor
Tail-servo
/
Yaw axis
Copter
Gyro
Gyro Offset
( function )
System settings
en
Mixing