Installation Instructions - Truma AS99 Mode D'emploi

Installation instructions

Residual gas: No smok-
ing, no naked flames!
Gas filter installation must always
be carried out by an expert.
Pay attention to flow
direction and installation
position! The gas filter must
always be installed in a vertical
position (filter cup facing down).
The optionally available angle
bracket (part no. 50020-87000)
can be used to install the gas
filter if necessary.
The installation of the gas filter
must not adversely affect the
secure attachment of the gas
pressure regulation system.
14
The seals of the HP hoses
and the filter cup O-ring
must be properly inserted and
undamaged.
Installation without
accessories
Fitted directly to gas pressure
regulation systems with
90° angled inlet screw connec-
tion M20 x 1.5 external thread.
Fitted directly to two-cylinder
changeover units with hori-
zontal inlet screw connections
M20 x 1.5 external thread
( 2 gas filters required)
Installation with accessories
Fitted to gas pressure regu-
lation systems using optionally
available elbow union 90°
(part no. 50020-56000).