Teac CR-H500NT Mode D'emploi page 11

AC Power Cord
A
Plug this cord into an AC wall socket.
< Unplug the power cord when you are not going to
use the unit for long periods of time.
B
Wireless LAN antenna
If you can use a wireless LAN in your installation site,
the unit connects to the LAN using the wireless LAN
antenna. Stand the antenna up to use it.
C
ETHERNET port
To use a wired Internet connection, connect the
ETHERNET port of this unit to the ethernet network
using a commercially available ethernet cable.
AUX 1 jacks
D
These jacks transmit an analog 2-channel audio
signal. Connect the components using commercially
available RCA pin cables.
Make sure to connect the cables as follows:
white plug w white jack
w red jack
red plug
White (L)
Red (R)
If you want to use a recorder (ex. a cassette deck or a
CD recorder, etc.) with the CR-H500NT, connect the
output jacks of the recorder to the AUX 1 IN jacks
of the CR-H500NT, connect the input jacks of the
recorder to the AUX 1 OUT jacks of the CR-H500NT.
< Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
(L: left channel)
(R:right channel)
White (L)
Red (R)
PHONO jacks
E
Connect the turntable's RCA pin cable to the PHONO
jacks.
Make sure to connect the cables as follows:
white plug w white jack
w red jack
red plug
< Be sure to insert each plug securely. To prevent
noise and humming, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
< Moving Magnet (MM) cartridges can be used for this
unit.
F
SIGNAL GND
Connect the ground lead of the turntable to this
terminal.
< This is not a safety earth.
< If the turntable's ground lead is not connected to this
terminal, hum noise may be heard.
(L: left channel)
(R:right channel)
11