Operation; Cleaning - Proficook PC-TG 1017 Mode D'emploi

• Grill your foodstuffs directly on the CERAN
surface (6).
• If you want to use oil ensure that it is highly
heatable, such as sunflower oil. Do not use
olive oil or butter, since they start smoking
already at low temperatures.
• Prepare your food in any desired sequence.
Remove food residues to avoid transferring its
taste to the next food. Move the food residues
carefully with a spatula into the fat collection
tray.
On/Off
• Operate the appliance via the thermostat (4).
• Left of the thermostat is a marking (5) showing
the current thermostat setting.
• Setting the arrow to the
marking position switches
the appliance off
(see illustration).
Electric Connection
1. Ensure that your mains power corresponds
with the specifications of the appliance. The
specifications are printed on the type label.
2. Ensure that the appliance is switched off.
3. Connect the mains cable to a properly installed
and earthed 230 V~, 50 Hz wall outlet.

Operation

1. Attach the fat collecting tray (1) at the rear of
your tabletop grill.
2. Turn the thermostat clockwise to the desired
setting. Observe the following table.
Setting
LO
2
3
4
5
6
HI
®
Application
Warming
Warming
Cooking
Simmering
Searing
Grilling
Grilling
NOTE:
The indicator lamp (3) lights up when the
appliance is heating up. It turns on and off
during operation. This is normal and shows
that the temperature is thermostat-controlled
and maintained.
3. Prepare your foodstuffs like on any other grill.
End Of Operation
1. Turn the thermostat to switch the appliance off.
2. Disconnect from mains power supply.
3. Clean the appliance immediately after every
use.

Cleaning

WARNING:
• Disconnect from mains power supply before
cleaning.
• Do not submerge the appliance in water! This
may lead to electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasive
utensils for cleaning.
• Do not use aggressive or abrasive cleaning
agents.
CERAN ® Surface
• Remove food residues with a spatula as long
as the appliance is still warm.
• If food residues have dried and hardened:
1. Wet the surface with a sponge.
2. Heat up the tabletop grill for a few minutes
on HI position.
3. Remove the food residues into the fat col-
lecting tray as described before.
4. Turn the thermostat to switch the appliance
off.
5. Disconnect from mains power supply.
®
• Wash the CERAN surface with a soft sponge
and a little water and thoroughly dry afterwards
with a soft cloth.
37