Publicité
Les langues disponibles
Les langues disponibles
–
Fill the water reservoir with clean tap
water.
–
Place the iron on its rest and insert the
plug into a suitable wall socket.
–
Use the On/Off switch
appliance.
symbol starts fl ashing to indicate
–
Th e
that the boiler is heating up.
–
Set the temperature control knob to the
required ironing temperature according
to the ironing symbols.
–
As the iron is heating up, the temperature
indicator lamp on the iron will be on.
It goes out once the required ironing
temperature is reached.
–
Use the + and – buttons to select the
desired steam output:
minimum
,
medium
,
maximum
.
–
While the appliance is heating up, the
display shows the symbol for the steam
pressure already available for steam
ironing
–
Th e symbol
the water in the boiler has reached the
required temperature.
–
As soon as the steam output indicator '
appears in the display, the water in the
boiler is suffi ciently hot for steam ironing.
–
Before starting to iron, the sole plate
should be cleaned by passing it over a
clean cotton cloth, while using the steam
jet function; this helps to fl ush out any dirt
residues or lint particles trapped inside the
openings in the sole plate.
–
You can now start ironing; press the steam
button as required.
–
Th e steam function may also be used with
the iron held vertically, to remove creases
or wrinkles from fabrics.
If, during ironing, the water reservoir
becomes empty, simply re-fi ll it as
described in the section 'Filling with
water' . Always replenish the water in
good time, whenever the symbol
fl ashing.
Turn the appliance off aft er use. Replace
to turn on the
.
disappears out once
starts
the iron on its rest on the steam generator
and remove the plug from the wall socket.
Once the appliance has cooled down
suffi ciently,
connecting hose may be carefully wound
up and stored in the side holder.
Dry-ironing
For dry-ironing (i.e. ironing without steam),
proceed as described in the section Steam
ironing and use the + and – buttons to select
the 'no steam'-symbol
Spray function
Th e spray function can be used at any time.
To fi ll the water tank for the spray function,
pull off the entire spray assembly and take
off the tank. Fill the tank with clean water,
observing the 'Max' marking and replace
it. Ensure that the two arrow markings are
properly aligned, i.e. facing each other.
Replace the spray assembly.
Automatic switch-off
If the appliance is not used for more than
10 minutes, it will automatically switch into
'Pause' mode. Th is is indicated by a beep
4'
signal and the
To continue ironing, re-activate the appliance
by pressing the On/Off switch
button and allow it to re-heat for around two
minutes.
General care and cleaning
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has completely cooled down.
To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
Do not use abrasives or harsh cleaning
solutions.
If necessary, the appliance may be wiped
with a dry lint-free cloth.
Iron
–
Starch, fat and other deposits on the sole
plate may be removed with a woollen
13
the
power
cord
in the display.
pause symbol in the display.
or the steam
and
Publicité
