STEINEL IS 2160 Mode D'emploi page 16

Technical specifications
Dimensions:
Output:
Connection:
Angle of coverage:
Pivoting range:
Reach:
Light threshold:
Time setting:
Light threshold:
Enclosure:
Temperature range:
Troubleshooting
Malfunction
Without power
Does not switch 'ON'
16
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
(H x W x D) 113 x 78 x 73 mm
600 watts max . (resistive load, e.g. filament bulb)
500 watts max. (uncorrected, inductive,
cos φ = 0.5, e.g. fluorescent tubes)
500 watts max. (series corrected)
500 watts max. (shunt corrected, at C ≤ 45.6 µF)
Electronic ballasts, capacitive
e.g. low-energy lamps,
6 each max., C ≤ 132 µF
230 – 240 V, 50 Hz
terminal block suitable for following supply leads:
3-core Ø 1.5 or 2.5 mm
160° with sneak-by guard
40° horizontal, 70° vertical
12 m max.
2 – 2000 lux
8 sec. – 35 min. (factory setting: 10 sec.)
2 – 2000 lux (factory setting: 2000 lux)
IP 54
-20 °C to +50 °C
Cause
Fuse blown, not

switched 'ON'
Short circuit

Twilight setting in

nighttime mode during
daytime operation
Bulb blown

Mains switch 'OFF'

Fuse blown

Detection zone not

properly targeted
or 5-core Ø 1.5 mm
2
Remedy
Renew fuse, switch

'ON' mains power
switch, check wiring
with voltage tester
Check connections

Readjust

Replace bulb

Switch 'ON'

Renew fuse, check

connection if
necessary
Re-adjust

2