STEINEL IS 2160 Mode D'emploi page 15

Wiring examples
1. Light without neutral conductor
3. Connection using series switch
for manual and automatic operation
1) e.g. 1-4 x 100 W filament bulbs
2) Service load, light of 600 W max. (see Technical specifications)
3) IS 2160 connection terminals
4) Indoor switch
5) Indoor series switch, manual, automatic
6) Indoor double-throw switch, automatic, permanent light 'ON'
Operation/Maintenance
The Infrared Sensor is
suitable for switching light
'on' and 'off' automatically.
The unit is not suitable
for special burglary alarm
systems since it lacks
the tampering protection
prescribed for this pur-
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
2. Light with neutral conductor
4. Connection to double-throw switch
for permanent light 'ON' and automatic
operation
Setting I: automatic operation
Setting II: manual operation for permanent
light 'ON'
Important: the unit cannot be switched
off, but operated only at settings I and II.
pose. Weather conditions
may affect the way the
motion detector works.
Strong gusts of wind,
snow, rain or hail may
cause the light to come
'on' when it is not wanted
because the sensor is
unable to distinguish sud-
den changes of tempera-
ture from sources of heat.
The detector lens may be
cleaned with a damp cloth
if it gets dirty (do not use
cleaning agents).
15