Foundations 5806086 Instructions D'installation page 2

ADULT INSTALLATION REQUIRED.
TOOLS REQUIRED:
Level (A)
Measuring tape (B)
Power drill with 3/8" bit (C)
Power screwdriver with bull nose phillips bit (D)
•
READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF WALL SEAT.
•
Unpack carton and identify all parts.
Note: Backer plate warning on wall seat is no longer relevant, the backer plate is an obsolete accessory and is no
longer needed for the installation process.
Parts Description
Hardware for installation:
1/4 - 20 x 1-1/4" Machine Screws
1/4" Flat Washers
1/4 -20 x 9/16" T-Nuts
1-1/4" Caps
1/4 - 20 x 1-1/4" Machine Screws
IMPORTANT:
- The enclosed hardware is for through-bolt mounting on a
1" thick steel partition only. If mounting unit on a partition
of different thickness or on a wall, provide the appropriate
backing and hardware.
-
Wall seat MUST be mounted in a convenient location at
or near the same height as the toilet tissue dispenser. If
mounting in a changing room, mount so bottom of wall
seat is approximately 20-1/2" from the
there is adequate clearance in front of the seat for safe
operation.
•
The wall seat is no stronger than the anchors or walls to which they are attached and, therefore, MUST be
order to support the weight they are intended to support. Contact an architect or building contractor if any questions. in
•
Check mounting hardware at least once a month to ensure screws are tightly fastened.
•
Always secure child with restraint system. NEVER leave child unattended.
•
DO NOT mount to a door.
WWW.RESTROOMDIRECT.COM
ASSEMBLY INSTRUCTIONS
PARTS LIST
1/4 -20 x 9/16" T-Nuts
1/4" Flat Washers
Make sure
WARNING
1
704 • 937• 2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115
A
C
D
A.D.A. Compliance:
307.2 Maximum Protruding Objects
308.2 Forward Reach
308.3 Side Reach
309.4 Operation
Compliant when properly installed.
B
Quantity
4
4
4
4
1-1/4" Caps
secured