Publicité
Finish-sanding plate
(without velcro backing) (see figure
When operating mainly with standard sanding
sheets without velcro backing, it is recommended
to use the finish-sanding plate without velcro
backing.
Due to its plane sanding plate surface, optimum
results are reached, particularly for finish sand-
ing.
Operating Instructions
Before any work on the machine itself, pull
the mains plug.
The removal performance when sanding is deter-
mined primarily by the selection of the sanding
sheet and the oscillation rate.
Excessive sanding pressure does not lead to in-
creased sanding capacity, but to increased wear
of the machine and the sanding sheet.
A sanding sheet that has been used for metal
should not be used for other materials.
Use only original Berner sanding sheets and ac-
cessories.
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Berner power tools.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine it must be
disposed of safely.
B
)
To be fitted
by qualified
professional only
English - 4
Environmental Protection
Recycle raw materials instead of disposing as
waste
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for catego-
rized recycling.
Declaration of Conformity
We declare under our sole responsibility that
this product is in conformity with the following
standards
or
standardization
EN 50 144 according to the provisions of the di-
rectives 89/336/EEC, 98/37/EC.
Mario Ferretti
CEO
Berner GmbH
Bernerstraße 6
D-74653 Künzelsau
Subject to change without notice
documents:
Jean-Marie Biren
Managing Director
Sales and Marketing
Publicité
