Installation Instructions; Regulations - Truma GSE Mode D'emploi

Installation instructions

Only competent and trained
staff (experts) are permitted
to install and repair the Truma
product and to carry out the
function test, at the same
time observing the installation
and operating instructions
and the currently recognised
technical regulations. Experts
are persons who, based on
their specialist instruction
and training, their knowledge
and experience with Truma
products and the relevant
standards, can carry out the
necessary work properly and
identify potential hazards.
The operating instructions
for this Truma appliance are
an important part of these
installation instructions and
must be followed. Read the
installation instructions, the
operating instructions and
the safety instructions care-
fully before commencing the
work, and then comply with
them.
The control panel must
not be installed in the
cylinder box.
Pay attention to the flow
direction (see arrow) when
installing the gas remote switch.
When using vehicle-specific or
manufacturer-specific control
panels, the electrical connection
must be made according to the
Truma interface descriptions
(contact Truma Service). The in-
staller (manufacturer) is respon-
sible for providing the user with
operating instructions (and the
information that is printed on the
control panels).

Regulations

The rules in the instal-
lation and operating
instructions and the respective
valid laws, directives and stand-
ards must be observed. The ap-
pliance's operating permit, and
consequently also the vehicle's
operating permit in some coun-
tries, are rendered void if the
regulations are not followed.
19