Flex DW 45 18.0-EC Notice D'instruction D'origine page 26

Operating instructions
CAUTION!
Do not grip the rotating screwdriver head.
Stop sleeve
Screwing in screws:
1. Insert appropriate screwdriver bit.
2. Set screw-in depth.
3. Set direction of rotation (clockwise).
4. Grip electric power tool with one hand on
the handle and assume working position.
5. Place screw on the screwdriver bit.
The screw is held by magnetic force.
6. Press screw tip against the workpiece
to be screwed in place until the stop
sleeve is positioned on the workpiece.
Hold electric power tool at right angles
to the surface of the workpiece!
7. Switch on the power tool.
The screw is screwed into the workpiece
until the set screw-in depth is reached.
Check screw-in depth, change if required.
NOTE!
When the preset screw-in depth is reached,
the drive is disengaged, the screwdriver bit
stops turning.
8. When you have finished fixing screws,
switch off the electric power tool.
At the end of work:
9. Move the direction of rotation selector (3)
to the middle position.
26
Loosening screws:
1. Insert appropriate screwdriver bit.
2. Set direction of rotation (anti-clockwise).
3. Grip electric power tool with one hand on
the handle and assume working position.
4. Place screwdriver bit on the screw to be
loosened.
5. Switch on electric power tool by
pressing the switch.
The screw is loosened.
6. After unscrewing the screw, release the
switch.
At the end of work:
7. Move the direction of rotation selector (3)
to the middle position.
Screw magazine
Screwing in screws:
1. Inserting screw blet.
2. Set screw-in depth.
3. Set direction of rotation (clockwise).
4. Grip electric power tool with both hands
on the handle and assume working
position.
5. Press depth stop (for screw length)
against workpiece to be screwed in
place. Hold power tool at right angles
to workpiece surface!
DW 45 18.0-EC