Noise And Vibration - Flex DW 45 18.0-EC Notice D'instruction D'origine

Special safety instructions
Identify the power tool with stickers only.
Do not drill any holes into the housing.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power
tool is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty K:
otal vibration value (when fixing screws):
– Emission value a
– Uncertainty K:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 62841 and may be used to compare
one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different appli-
cations, with different accessories or poorly
maintained, the vibration emission may
differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use.
This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
18
: 71 dB(A);
pA
: 82 dB(A);
WA
: <2.5 m/s
h
1.5 m/s
3 dB.
2
2
DW 45 18.0-EC