Instructions For Use - Flex DW 45 18.0-EC Notice D'instruction D'origine

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack power tool and accessories and

check that no parts are missing or
damaged.
Attach the belt clip and bit holder with

the enclosed fastening screw.
Inserting/replacing the battery
Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
22
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Battery state of charge
Press the button to check the state of

charge at the state of charge indicator
LEDs.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
The indicator goes out after 5 seconds.
NOTE
Follow the instructions for charging the
battery in the operating instructions for the
electric power tool and the battery charger.
Inserting the tools
Screwdriver bit
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Before performing any work on the electric
power tool, move the lever for selecting
direction of rotation (3) to the middle
position.
DW 45 18.0-EC