Clatronic DBC 2899 Mode D'emploi & Garantie page 33

How to Use
• Fill the water reservoir at the refi ll opening (2), using a fi lling container. Prefe-
rably use distilled water or clear tap water (maximum water hardness level 2).
If water is harder, used distilled water only.
• Do not fi ll battery water, water from the clothes dryer and water containing
additives (such as starch, perfume, softener or other chemicals) into the water
reservoir. This could damage the iron due to residues forming in the steam
chamber. These residues may cause impurities to the fabric when dropping
out of the holes in the soleplate.
NOTE: Only clothes should to be ironed with this machine.
Ironing without steam (steam regulator turned to position „b")
1. Place the iron on its stand.
2. Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
3. Sort out the garments according to their ironing temperatures. Start with the
lower temperatures. It is set with the thermostat (3):
• Synthetics, silk
• • Wool
• • • Cotton, linen
MAX
4. The indicator light is on. As soon as the indicator light goes out the desired
operating temperature has been reached (approx. 3 minutes). Now you can
start ironing.
5. Always pull the plug out of the socket after using the iron.
Steam Ironing
For this a high temperature is needed (cotton, linen). The quantity of steam can
be regulated using the steam quantity regulator (1).
b
no steam
Small steam volume
Large steam volume
Extra steam can be added with the steam jet function (7).
Caution: the steam is hot. Danger of scalding!
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
6....-05-DBC 2899 33
Using the Machine
low temperature
medium temperature
high temperature
maximum temperature
GB
33
29.09.2004, 11:24:19 Uhr