Product Operation; Global Operation; Park Mode; Command Mode - ADEUNIS DRY CONTACTS IP68 Guide Utilisateur

Lorawan 863-870
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DRY CONTACTS IP68 LoRaWAN 863-870 - Guide utilisateur / User guide version V1.0.0

2. PRODUCT OPERATION

2.1. Global Operation

Important: adeunis® use the most significant byte first format.
The product has several operating modes:
FR
EN

COMMAND MODE

2.1.1 PARK mode

The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the product out of the Park Mode pass
a magnet across it for a duration higher than 5 seconds. The green LED illuminates to indicate the detection of the magnet and then flashes
quickly during the product starting phase.
The device then sends its configuration and data frames.
2.1.2 COMMAND mode
This mode allows the user to configure the registers of the product.
To enter into this mode, connect the micro-usb of the device to a computer or smartphone and use the IoT Configurator to configure it.

2.1.3 PRODUCTION mode

This mode allows the user to operate the product in its final use. It should allow a maximum of autonomy to the product.

2.1.4 Management of the low battery

When the product detects that the battery is not anymore in capacity to deliver the energy needed to send a frame (extreme temperatures or
end-of-life of the battery) it waits to be in capacity to transmit. If it detects that the delay generated is longer than 1 minute it informs the user
via the "battery low" flag in the status byte of each frame.
Product should
send a frame
The battery low alarm is switching off if the battery is replaced or when the temperature conditions are favorable for the proper functioning of
the battery.
Command send-
ing by serial link
Auto adaptation
(cf management
of the low battery)
yes
Battery is
The product is
no
sufficient
waiting to be
to send the
able to emit
frame
?
PARK MODE
Presence of a magnet
on the product >5s
PRODUCTION MODE
Send "battery
low" flag
OFF
(dead battery)
yes
Delay
is lower than 1
minute ?
Replacing the battery
"Low battery"
no
alarm appears in
status byte
The product
sends its frame
46 of 63

Publicité

Table des Matières
loading

Table des Matières