Installation - Waeco CoolFun CD-30 Notice D'emploi

CD-30.book Seite 18 Donnerstag, 19. November 2009 2:14 14

Installation

6 Installation
Ensure that the positive cable is connected to the positive terminal
and the negative cable to the negative terminal.
To avoid voltage loss and therefore a drop in performance, the
cable route should be kept as short as possible and should not
be interrupted if this is possible. For this reason avoid additional
switches, plug or power strips.
When choosing the installation location, ensure that the air heated
by the liquefier can be drawn off.
➤ Determine the necessary cable cross section of the intake line using the
diagram below:
12 Volt device
➤ Connect your cooling device as directly as possible to the battery terminal
or to an outlet with a fuse of at least 15 A (12 V) or 7.5 A (24 V).
To screw the device in place use the screwing holes provided on
the side of the device (see fig. 3, page 2).
18
24 Volt device
Metres of cable (m)
CD-30