Maico MF-V75-8 Instructions De Montage page 6

● MF-V75-8: Recommended for apartment
and building renovation. For up to eight
75 mm flexible ducts.
● MF-V90-8: Recommended for apartment
and building renovation. For up to eight
90 mm flexible ducts.
The preferred installation for the
i
ventilation ducts is to lay them in a
suspended ceiling. Other installation
methods can also be considered,
such as laying them in the concrete or
in the damp course under the floor
paving.
6. Technical data
Dimensions (W x D x H) without
sealing plugs
7. Environmental conditions and
operating limits
● Maximum permitted temperature
of the air medium
8. Safety instructions
General
● Read the safety instructions
through carefully before
commissioning.
● Keep the instructions.
● Installation is only permitted
when carried out by trained
specialists.
● Only operate the air distributor
when it is completely installed.
● Modifications and alterations
to the air distributor are not
permitted and release the
manufacturer from any
guarantee obligations and
liability.
6
710 x 350 x 185 mm
+50 °C
Intended use
● For MAICO-Flex MF-F flexible
ducts.
● Installation in apartments and
houses.
● For air distribution in supply air
or exhaust air ducts.
● Surface mounting directly on
the wall or ceiling in
suspended ceilings.
● Any installation position.
● Only for indoor installation.
● Only with access to the
service opening.
9. Installation preparation
 Decide on the installation location. Take
the bend radius of the flexible ducts into
consideration.
 Make sure there is a level surface at the
installation location.
 Make sure there is access to the inspection
openings.
i
Notes
● Only install on walls, ceilings or brackets
with sufficient load-bearing capacity.
● Install the air distributor in suspended
ceilings with 4 threaded rods.
Danger of injury caused by
inadequate mounting.
 Make sure you use mounting
CAUTION
material, which is sized for the
purpose.
● Permitted connection duct to the KWL unit:
Folded spiral-seams duct Ø 160 mm.