Galletti EVO Manuel D'installation Et D'utilisation page 39

Possible situations:
in COOLING MODE:
- with on-board controller and configurations with
valve: the minimum available speed is maintained
even when the temperature is reached
- with on-board controller and configurations without
valve: every 10 minutes a 2-minute washing at
medium speed with the fan stopped allows the air
probe to perform a more precise room temperature
reading.
in HEATING MODE:
- with the heater on: ventilation is forced at medium
speed
- once the heater is switched off: post-ventilation is
maintained at medium speed for 2 minutes. (NB:
this ventilation will be completed even should the
thermostat be turned off or pass to the cooling
mode.)
VALVE
The control can manage 2- or 3-way ON/OFF (i.e. fully open
or fully closed) or modulating valves (valve opening can
and 100%).
range between 0%
ON/OFF VALVE
Valve (2- or 3-way) opening is controlled depending on the
operating setpoint and air temperature setpoint.
COOLING
et
HEATING
n
et-
EN
13
n
t. aria
et+
t. aria
et
IT IS strictly forbidden to reproduce this manual, even partially
Controller for units
MODULATING VALVE
Valve ( 2- or 3-way) opening is controlled depending on the
operating setpoint and air temperature setpoint. The opening
adjustment logic follows the diagrams provided below.
COOLING
ert ra
2
et
HEATING WITH 3-SPEED CONFIGURATIONS
et-2
HEATING WITH 4-SPEED CONFIGURATIONS
WATER CONSENT
Water temperature control for opening consent only
concerns configurations with 3-way valves and electrical
heater. In such configurations the water temperature will be
checked in the following cases:
Heating with heater: heater operation requires forced
ventilation; it is therefore necessary to avoid water that
is too cold from passing through the unit.
o
2 .
OPERATION MANUAL
et+ . et+2
et- .
et- et- .
.
EVO
a ie te
ert ra
2
a ie te
et
ert ra
2
a ie te
et
t. a a
FC66003554
Rev 00