Adjustment Menu; Setup Menu - Galletti EVO Manuel D'installation Et D'utilisation

ADJUSTMENT MENU

DESCRIPTION
Minimum cooling SET limit
Maximum cooling SET limit
Minimum heating SET limit
Maximum heating SET limit
Minimum humidity SET limit
Maximum humidity SET limit
Humidity hysteresis
Offset on humidity reading
Minimum value of modulating ventilation
Maximum value of modulating ventilation
Air probe offset
Water probe offset
Heating water probe offset
Economy Hysteresis
Cooling water consent SET
Cooling water consent hysteresis
Heating water consent SET
Heating water consent hysteresis
Dehumidification water consent SET
Dehumidification water consent hysteresis
Valve water consent SET
Valve water consent hysteresis
Heater water consent SET
Heater water consent hysteresis
Temperature minimum control SET
Temperature minimum control hysteresis
Neutral zone
Default values RESET
EN
9
Controller for units
DEFAULT
10.0 °C
35.0 °C
5.0 °C
30.0 °C
35%
75%
5%
0%
20%
100%
0.0 °C
0.0 °C
0.0 °C
2.5 °C
22.0 °C
5.0 °C
30.0 °C
7.0 °C
10.0 °C
2.0°C
30 °C
5.0 °C
39.0 °C
2.0 °C
9.0 °C
1.0 °C
5.0 °C
No
OPERATION MANUAL
IT IS strictly forbidden to reproduce this manual, even partially

SETUP MENU

From the main display, press the UP/DOWN keys to view the
following pages in this order:
Turning Economy function on
Enabling electrical heater use
Turning temperature minimum control on
Turning humidity control on
Humidity setpoint
If it is not possible to access editing of one or more entries,
you will need to preventively set the relative configuration
parameters. For example, to enable electric heater operation
you will need to preventively set it up in the configuration
parameters menu.
EVO
FC66003554
Rev 00