Reiner jetStamp graphic 970 Mode D'emploi Succint page 10

jetStamp graphic 970
Electrical and electronic waste devices
Waste devices must not be disposed of in the conventional household waste. They
must be returned to a special collection point for recycling of electrical and electro-
nic devices.
1. Preparation and Taking into Operation
1.1. Commissioning
The rechargeable batteries must be charged completely before the first use.
The charging time is approx. 3 hours. The rechargeable batteries are charged when the
green charge display
Inserting rechargeable batteries
Always replace all rechargeable batteries at once. Date, time and counter reading of the
numbering machine are retained when the rechargeable batteries are removed.
Open battery compartment
f
Place the textile ribbon flat across the compartment.
f
The textile ribbon serves simpler removal of the rechargeable batteries.
Ensure correct polarity and insert the rechargeable batteries.
f
Close battery compartment
f
Charge batteries
Only connect the device to the PC when the PCset graphic-Software was installed.
Installation of the PCset graphic software installs the required USB drivers. The USB
drivers are automatically recognised and loaded when the device is connected to the
computer. The device driver installation fails if the device is connected without the
PCset graphic software being installed.
Charging at a USB hub without dedicated power supply is not possible.
Connect the Micro-USB socket of the device
f
connect the mains unit to the mains.
Green charging indicator
1.2. Inserting Printing Cartridge
Inserting printing cartridge
Depending on ink type used, different Protective Nozzle Seals are required.
Use sealing of the enclosed printing cartridge.
Put the jetStamp graphic 970 in the base station
f
9
8
goes out.
Fig.

2
.
2
.
Fig. C

8
lights up.
Fig.

A
9
to the mains unit with the USB cable and
+ +
A B D
4
.